Brand |
SHIMA SEIKI
|
Variation |
V
|
Gauge |
5.7.12.14
|
Knitting Width |
Variable stroke, max 48” (122cm)
|
WideGauge® |
Wide range of gauge knit on a single machine ( V only).
|
Knitting Speed |
Max 1.4m/sec. Knitting speed varies according to yarn, gauge and other knitting conditions. Speed can be programmed for 10 separate categories.
|
Stitch Density |
120 levels, electronically controlled
|
Racking |
Motor- driven. Max 1 inch racking in each side ( 2 inches total) (V5G: Max 6.5-pitch racking on left side and max 6-pitch racking on right side). 1/2 and1/4 pitch also available from any position.
|
Knitting System |
Double KNITRAN® system, single carriage (R2CARRIAGE® system).
|
Transfer |
Simultaneous transfer, front or back, independent of carriage direction. Split stitch possible by exchanging yarn carriers.
|
Sinker System |
Spring-type moveable full-sinker system. Provides gentle holddown instead of forcibly pressing down yarn. v-Sinker TM standard on 16G and 18G .
|
Stitch Presser |
Special motor-drive. On/off adjustment. Press-down amount can also be set according to knit, transfer, etc.
|
Needle Hook Conversion |
Conversion between LL-size and MM-size possible without exchanging cams. ( V7G, V12G and V14G only )
|
Needle Selection |
Full jacquard selection via special solenoid actuators
|
Setup Device |
Takedown comb with special setup needles
|
Takedown Device |
Main/sub rollers. Changeable 99 levels, automatically adjustable on each level. Automatic opening and closing upon command
|
Yarn Carriers |
5-7G: 9 normal carriers. 12-18G: 7 normal carriers. Plating yarn feeders standard on carrier rails no. 5 and no. 6.
|
DSCS® |
Consistent loop length by digital control method. 4 lightweight, compact encoders ( V5G: 8 encoders ). Left side standard.
|
Yarn Feed Roller |
8 positions on left side standard (V7G: 10 positions). Left si de double roller standard (V5G: 10 positions, C18G: 8 positions). 10 positions on right side standard (V 5G only).
|
Side Tensions |
8 positions on each side (5G and 7G only: 12 positions on each side) Brake disk with multi-step adjustable dials.
|
Top Tension |
16 units ( SV5G and SV7G only 24 units) One-touch easy threading. Large knots cause machine stop Small knots cause 0-9 courses at specified knot detection speed, then automatically resume at set speed
|
Stop Motion |
Yarn break, large knot, fabric pileup, shock detection, piece count, over-torque, program error etc.
|
Drive System |
Belt drive. AC servo motor. No lubrication necessary.
|
Safety Devices |
Emergency stop switch. Emergency power off device. Full safety cover for noise-suppression and dust-proofing with stop motion sensor and interlock mechanism Ultra-low speed “crawl” setting. CE Mark. Operation lamp
|
Operation Lamp |
Green/normal operation. Flashing green/normal stop. Flashing amber/abnormal stop.
|